WCA July 2011

Analysis of surface flaws on drawn wire and wire breaks By Kazunari Yoshida, Tetsuo Shinohara, Tsutomu Yamashita and Atsuhiro Tanaka of Tokai University, Japan

Abstract: Using experiments and finite element method (FEM) analysis, this paper examines whether surface cracks on wire rods grow or are removed during drawing. The deformation behaviour of V-shaped, concave, and U-shaped transversal cracks were observed upon repeated drawing. The authors clarified the conditions under which these transversal cracks are removed in order to achieve a surface condition similar to that of the area without cracks. 1 Introduction The diameter of wires and bars pro- duced by drawing varies from about 10μm to 100mm. For any diameter of wire, breaking during drawing has a direct effect on productivity. Also, flaws on the surface of wires often cause fatigue breaking, the deterioration of mechanical proper- ties, and loss of commodity value. This is why surface flaws are the most common complaint of users. Furthermore, finer and longer wires

‘Inclusion’

‘Contamination’

‘Split End’

‘Tension’

‘Hollow End’

‘Pressed hollow’

❍ ❍ Figure 1 : Types of wire breaking

Inclusion

Hollow end

Contamination

Pressed hollow

Split end

Tension

Others

❍ ❍ Figure 2 : Percentages of causes of wire breaking during drawing of superfine gold wires

In this study, the causes of wire breakages in drawn wires of different diameters were examined. Analyses of wires with surface flaws and inclusions were performed experimentally and by a finite element method (FEM) to determine whether surface flaws and inclusions cause wire breakages or remain as surface flaws when drawing is repeated.

have recently been requested for use as the bonding wires of semi-conductors and in medical devices. Therefore, wire breaking and surface flaws are problems that must be solved. Many researchers have investigated the optimal die shape to reduce drawing force, measures to prevent wires from internal cracking (through the formation of central burst defects or cupping), the optimal lubricant, measures for reduction of residual stress and so forth. Useful findings have been obtained, but there have been few studies of measures to prevent wire breakage and on the effects of inclusions and surface flaws on wire drawing 1, 4 .

2 Types of wire breakage caused by drawing

Recently, the occurrence of wire breaking during drawing has greatly decreased due to reduced particulate segregation

65

Wire & Cable ASIA – September/October 2007 Wir & Cable ASIA – July/August 11