EoW November 2007

newmachinery & equipment launched in 2007 Hydropulsor leading the way Hydropulsor AB, based in Karlskoga, Sweden, is a leading manufacturer of high velocity impact cut off equipment (HVCU). Each model in Hydropulsor’s comprehensive line of HVCU equipment uses the adiabatic softening phenomenon and is capable of cutting most metals, round or profile, from bars or coils. The standard line of equipment consists of four models that range in sizes from the HYP30-15, capable of cutting bars or coil from 3-15mm in diameter (equivalent cross section for profile material), to the HYP30-70, capable of cutting bars up to 70mm in diameter (equivalent cross section for profile material).

Hydropulsor HYP30-15 cut off equipment with automatic bar feeder ▲

Custom HVCU equipment capable of cutting bars up to 90mm in diameter is also available. All Hydropulsor HVCU equipment can be purchased as stand alone units, or based on each customer’s specific needs, each model is offered as a turnkey solution and can include coil pay-off units and straighteners or bar feeders and un-scramblers. Based on proven performance in industry, Hydropulsor customers know they will receive high quality end cuts, with no burrs, no splits, and minimum pull down. Hydropulsor cut off equipment is environmentally friendly, using no coolants or cutting fluids and produces no scrap in the form of chips. Length or volume tolerances based on effective production rates exceed those found with either saws or shears. Tool life can range into the millions of cuts per die set with over a hundred thousand cuts between each sharpening. Tooling changes from one diameter material to another can take less than 10 minutes. Hydropulsor AB – Sweden Fax : +46 586 649 65 Email : info@hydropulsor.com Website : www.hydropulsor.com

360° check from CPA

A new innovation from CPA Srl is the ability to check the whole screw through 360° for possible impact defects or overlapping threads. The company already uses high resolution digital cameras to execute dimensional checks to screws and nuts for cracks (eddy current) and for keyhole depth. All of the tests are made on the rotation table, without the need to stop it, using running-up angular stations. CPA Srl – Italy Fax : +39 030 707169 Email : stefanovigano@cpasrl.it Website : www.cpasrl.it

Dimensional from CPA SrL

checks

▲

68

EuroWire – November 2007